How to fix a leaky shower head

Most of us enjoy a long, hot shower, but leaking shower heads can easily ruin what’s supposed to be the very best part of our day. While leaks can be severe, think about trying the next DIY fixes before you call a pro.

Unfortunately, you won’t know the cause of the leak until you get behind the wallsocket. For this reason, you need to consider trying to fix both faucet and mind prior to calling a plumber.

Though there are several shower head types that cost anywhere from $25 to $250, the process to fix a leak is continuous. In case the problem falls on the shower head, the subsequent steps will clean it up very quickly.

Supplies Needed:

  • Towel
  • Plastic washer
  • Rubber O-ring
  • Pliers
  • Crescent wrench
  • Enormous bowl
  • Distilled white vinegar
  • Old toothbrush
  • Teflon tape

How to Stop a Leak in Your Shower Head

Shut off the water supply. You ought to be able to turn off the water to just the shower, but if not, you’ll have shut off the water to the whole house.

Cover the drain and underside of the shower with a huge towel.

Remove your best shower head. Consider unscrewing with your palms. If you cannot remove, take your pliers and crescent wrench to remove in the wall.

Replace rubber or washers O-rings within the shower head should they look worn out or damaged. When washer and O-ring are in good shape, then rewrap the threads on the pipe using Teflon tape.

Wash your shower head while it’s off the wall. Let it sit for 2 hours.

Scrub the shower head with hot water. Use an old toothbrush to scrub between the nozzles. Then, dry the shower head with a clean towel.

Reattach the shower head. Don’t fix too closely in the event that you plan on frequently cleaning the shower head.

Turn the water back on and see if the shower still leaks. If it does, proceed to the next steps for another possible solution.

Fixing the Faucet

For this, you will have to replace the cartridge within the faucet.

Note: the following steps are for single-handle faucets.

Supplies Needed

Shut off the water supply.

Cover the drain and bottom of the shower with a huge towel.

Eliminate handle cap in the middle of the faucet with a little pocketknife or awl. It should come off with just a little bit of stress. You need to see a twist thread now.

Remove the handle screw with an proper screwdriver. If the handle doesn’t come off, try blowing it using a hair dryer or employing a handle puller.

Remove the retaining clip, which looks like a small metal horseshoe, in addition to the cartridge. You have to remove this retaining clip to replace the capsule. Lift it up with a little screwdriver. After that, remove the washer enclosing the centre bar.

Unscrew the hex screw and nut with your wrench.

Pull out the present cartridge. You will need pliers to remove it in the wall. Some stores incorporate specific cartridge pullers with fresh cartridges. Pullers are unique to the faucet.

Make sure the replacement cartridge will be the specific same as the one that you just removed. Align the new cartridge set up and install using the preceding steps in reverse sequence.

Turn the water back on. Turn the shower on and make sure there are no leaks.

Now, you have done everything you can to fix a leaking shower head. If the issue persists, contact a local plumber so that you can get back to the long and luxurious showers you have earned.

Leave a Reply

Your email address will not be published. Required fields are marked *